Through the screw to connect the joint, and through the bolt hole to inject the sealant. The operation procedure: in line with the dimension of the diameter of the bolt, select the screw that matches the corresponding specification to inject the joint, disassembling the bolt and the nut, the screw is injected to screw down the nut. The filling gun is met through injecting the sealant. It could match M12, M14, M16, M18, M20, M22, M24, M27, M30, M32, M34 and M36 (altogether twelve specifications) for use of bolts.
the sealants are injected into the clamp through this injection valve. there are also other hardware accesories indispensible in the pressue sealing project. other relevent parts are in the followings:
Special Equipment for Pressure Sealing Construction
Name | Specification | Unit | Amount |
TXY-II Filling Tool | Set | 1 | |
Self-reset Filling Gun | ?? II Type | Piece | |
Manual High Pressure Pump | 0 60Mpa | Set | |
Manometer | 0 60Mpa | Piece | |
Gauge Stand Joint | Three-pass | Piece | |
Package Joint | Closed | Set | |
High-pressure Hose | 5M | Piece | |
Introduction Valve | M12 | Piece | 10 |
Commutating Joint | 90 ° | Piece | 2 |
Commutating Joint | 120 ° | Piece | 2 |
Screw Filling Joint | M12-M36 | Set | 1 |
Belt Tightener | Manual | Piece | 1 |
Steel Band Card |
| Piece | 10 |
Steel Band | 1.25*30mm | Meter | 20 |
Multi-purpose Callan |
Big, Medium, Small |
Set | 1 |
Chargeable Electric Drill | 10mm |
Piece | 1 |
Long Drill | 4*200mm | Piece | 5 |
Acid-proof Thermal-insulation Gantlet |
| Pair | 2 |
Hard Hat with Veil (Headgear) |
Piece | 2 | |
Multi-purpose Toolbox |
| Piece | 1 |
Note: The table is for general allocation project, and each using unit could make adjustments subject to its own working conditions.
Nut With Injection Hole Connection